Apr 15, 2001 · Measuring a cell/battery with no operational load doesn't tell much. The open load of a new CR2032 could measure 3.1-3.2 volt, as you can see, you can't really tell about the cells you bought. Last edited: Mar 22, 2011

Aug 11, 2003 · IIRC, a new CR2032 is something like 3.3v. Three new AAA alkalines in series will be 4.8v. Two would likely work fine (3.2v), but by the time they're half-depleted it will be down to around 2.6v, which might not be enough voltage to power the scale. Even so, it will give more run time than a CR2032.

Jul 15, 2016 · I have a situation where I've replaced a generic (GLD brand / Chinese battery) CR 2032 coin cell battery in a remote control and the device didn't work with the new battery. I'd purchased a lot of five batteries together and all five of the new batteries failed to …

Mar 20, 2002 · I saw on www.brightguy.com a CR2032 that is 1.95. Their CR 2016's are also 1.95. If this is true, wouldn't a economical replacement for 2 CR2016's be ONE CR 2032? <HR></BLOCKQUOTE> I learned to replace 2 2016s with a 2032 in a Turquoise Photon2 from posts on this board, and I have found it to be extremely economical.

Feb 12, 2013 · The analysis is more complex for pulsed loads, e.g. ultra low energy wireless sensor or Bluetooth low energy devices. For a good introduction see Nordics's white paper High pulse drain impact on CR2032 coin cell battery capacity and TI's white paper SWRA349: Coin cells and peak current draw.

Apr 3, 2003 · Interestingly, I bought a Microlight 1 in yellow today. It uses a CR2032. Double checking, yes, my white photon 3 uses two CR2016. Investigating more I went to Photon's Web Site, and it seems that the battery requirements are based on the LED color. Red, Orange, Yellow, Infrared use a CR2032 Green, Turquoise, Blue, Purple, White, UV use x2 CR2016.

Apr 15, 2001 · At work had an older compact PCI, PC. Basically it's a whole PC, mb, cpu and memory on a single board that fits into a single compact PCI slot used for specialty purposes. Anyhow it had lost it's CMOS settings and upon inspection found the CR2032 battery used for backup was mounted vertically and soldered between two tabs.

Mar 25, 2008 · Its hard to use a voltmeter to determine capacity of a lithium battery, but yes 2.85v can indicate a fully depleted battery. Your novatac has a better battery capacity detector built in then almost anything you can buy so when the low battery warning kicks in its time to toss it.

Mar 26, 2008 · To test the tester I discharged a AA alkaline battery in 100mAh steps and put it on the tester for each step (I discharged with 100mA). Each time I checked the state on the ZTS I did multiple tests, if the tester changed between two values I recorded a value between, i.e. a indication of both 60% and 80% was recorded as 70%.

Dec 18, 2014 · The failed battery is a KTS Lithium Battery/Japan STD/CR2032. I read a little about some real basic differences between Lithium-ion and Lithium batteries before I came here. 1. Could you reccomend a good solid replacement battery or the best preferred type you would install between Lithium and Lithium-ion? 2.